This bookmark was made in Hueforge.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 145x42mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
   PLA BambuLab Basic Blue 
   PLA BambuLab Basic Pink 
   PLA BambuLab Basic Yellow 
   PLA BambuLab Basic Jade White 
This print uses 4 unique filaments

Swap Instructions:
   Start with Blue
   At layer #8 (0.72mm) swap to Pink
   At layer #13 (1.12mm) swap to Yellow
   At layer #20 (1.68mm) swap to Jade White for the rest.

Do not change the Z height. You can adjust the X and Y size.

• Yes, you can sell prints of this model.
• You do not have to buy a license or join my club.
• You only need to give proper attribution by mentioning that I designed it.