A bed leveling wheel for the Creality CR-10s printer to make fine adjustments to bed height.

Thank you to Oggie for supplying the original idea and the Fusion 360 file which helped enormously.

When I printed Oggie's design I found that the spline diameter was too small to match my printer so I took his Fusion 360 file and modified the spline. Inevitably I took it a bit further and came up with a new spoke design - it was a good excuse to get to grips with Fusion 360 since I normally use CATIA at work and I wanted to try something different.

The inspiration for the spoke design came from googling automotive alloy wheel designs - one of the first pictures was of an orange Bugatti Veyron wheel so the decision was made!

PLEASE NOTE:

From posts on Facebook it appears that some people have issues with fitting while others do not. This makes sense because it's why I originally re-worked Oggies design. It would appear there is some variance in size probably due to different suppliers or a second mould tool made to increase production that isn't quite the same. For this reason I have included my Fusion 360 file should anyone wish to change the spline diameter to suit the adjuster on their machine. I suggest printing the middle part only (use fusion or mesh manipulator of choice to split it off) first to do a test fitting. If anyone would like to supply a measurement of the outer diameter (over spline and between spline) I will make additional sizes available so people can measure theirs and refer to a table to see which one to print off. Any help would be appreciated.

Hope you like it!

Oh and if you make it, please register it or leave some feedback so I can improve the design.

Thank you

Rich