3D models for a blind controller box and wall mount as detailed in this post https://www.reddit.com/r/DIY/comments/k2qc4f/diy_wifi_enabled_roller_blind_motor/

Supports are needed for the controller box, but aren't needed for any of the other items. I also had to make minor post print modifications to the wall mount to allow the cables to feed through. This required taking a pair of cutters to make holes for the box to correcty seat in the mount. The holes that had to be modified was the power input and the end stop switch wire output.

The motor spacer is screwed into the underside of the motor with 2 m2 bolts.

The lid is screwed into the box with 4 self tapping M2.4 screws.