Hook
Coolcabana
Hanging
Beach
COOLCABANA HOOK
Print Profile(1)
- 0.16mm layer height, 2 walls, 15% infill
1-disc
PLA
Designer
10
4
Released 2025-05-20
Print a few of these off and clip them onto the rods. You'll never be without hanging space again at the beach! They pack up and down with the Coolcabana so you don't need to remove them each time. Simple but strong these get the job done.
No supports required.
At least 15% infill
0.16 - 0.35 Layer Height (doesn't matter as they are not really seen.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Models(2)
- COOLCABANA-HOOK.3mfDesigner
52.79 KB
2025-05-20
COOLCABANA-Hook.stlDesigner223.62 KB
2025-05-20
No more
