Soap dish
Basic Soap Dish
Print Profile(0)
4
2
Released 2026-05-01
a simple soap dish, with some slight ribs to minimize the contact area with the soap bar once wetted (which would then adhere too much to what is below it and also would over time lead to unneccesary buildup)
printed mine in PLA which for “just needing to be there” is plenty capable.
I treat them as disposable – ie if they get too gros they get discarded and reprinted as they do not take lots of material
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
Seifenkiste.stlDesigner
70.98 KB
2026-04-30
No more
