Inspired by the TIPPMANN ARMS 22lr Gatling Gun.

Look,
I thought it would be a fun idea, OK?
I realise it isn't that practical to have a rapid firing, multiple barrelled, crank powered, glorified wiimote holder sat on your coffee table, where it would be preferable to have three hands to operate it.

But it all works!
With some caveats...
You will need your Wiimote sensor up above your screen and, if you want the barrel not to interfere with the Wiimote (your mileage may vary), you will need to swap out to the nonblock versions of the barrel and rail in use.
The chain will probably jam if you angle up or down, but it will also unjam just by reversing direction.

The crank handle has a connection on both sides so you can decide which side you would like it on or even have two!

I printed mine using basic PLA with a 5% infill, mainly because I go through many versions. But it all worked well, apart from the tripod long legs (T_Long) - the smallest downward pressure broke both of mine at the connection point, so I would suggest a bit higher infill for those. It will remain a weak point, so try to resist sitting on it.

Please consider taking it out for a spin...

MY PATREON & PATREON SHOP.
https://www.patreon.com/3DFreeman

Thanks for all your continued support!