This bookmark was made in Hueforge.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 145x42mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black
    PLA BambuLab Basic Blue
    PLA BambuLab Basic Orange
    PLA BambuLab Basic Yellow
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #9 (0.8mm) swap to Blue
    At layer #12 (1.04mm) swap to Orange
    At layer #18 (1.52mm) swap to Yellow for the rest.

Do not change the Z height. You can adjust the X and Y size.

• Yes, you can sell prints of this model.
• You do not have to buy a license or join my club.
• You only need to give proper attribution by mentioning that I designed it.