This is a detailed, 3D-printed bust of Vegeta, the Prince of all Saiyans from the Dragon Ball series. The figure is made from a single filament, giving it a smooth, matte gray finish that highlights the sharp lines and contours of his iconic spiky hair and stern expression.

3D Printing Details and Technical Sheet

Technical Sheet

• Model Name: Saiyan Prince Bust
• Version: 1.0
• File Format: .STL
• Dimensions (default): 150mm (H) x 120mm (W) x 80mm (D)
• Material: Gray PLA (Polylactic Acid)
• Infill: 15% (Grid or Gyroid pattern recommended for stability and material saving)
• Supports: Required for the spiky hair and chin. Tree supports are highly recommended for easier removal.
• Build Plate Adhesion: Brim or Raft recommended for better bed adhesion.

Printing Steps

1. Slicing: Import the "Saiyan Prince Bust.stl" file into your preferred slicer software (e.g., Cura, PrusaSlicer, Simplify3D).
2. Settings:
   • Layer Height: 0.16mm for a good balance between detail and print time.
   • Print Speed: 50mm/s for most parts, reduced to 30mm/s for outer walls to ensure a smooth finish.
   • Hotend Temperature: 200-210°C, depending on your PLA filament.
   • Bed Temperature: 60°C.
3. Supports: Enable supports and set the overhang angle to 50° or higher. Use tree supports if your slicer supports them, as they are easier to remove without damaging the model.
4. Adhesion: Add a brim with a 5-10mm width to prevent warping, especially at the base.
5. Print: Transfer the G-code to your 3D printer and begin the printing process. The estimated print time is approximately 15-20 hours, depending on your machine and settings.
6. Post-Processing: Carefully remove the brim and all support structures. Use a hobby knife or pliers for hard-to-reach areas. Light sanding can be done to smooth out any rough spots. The model is now ready for display or can be primed and painted for a custom look.