Tired of your coasters roaming free? Bored of coaster holders that are blank and lifeless? This sleek coaster holder wrangles up to 12 or 20 coasters (each 5 mm thick) into one tidy, stylish stack

But here’s the twist: the front and back panels are a blank canvas for your creativity. Simply glue one of your coasters onto each side, and bam, instant personalization! Match your set, mix styles, or glue on something wildly unrelated just to confuse guests.

Features:

• Holds up to 12 or 20 coasters, two different models, each 5 mm thick (For my coasters, 4mm thick plus a 1mm thick cork cylinder)

• Fully customizable ends - just glue your favorite coaster (or anything flat) to the front and back. Example image here:

  

• Keeps your coasters organized and ready for beverage duty
• Four 11mm diameter pockets on the bottom for rubber feet to keep the holder from sliding everywhere
• Prints easily - no supports required
• Perfect for living rooms, offices, man-caves, she-sheds, or your secret underground drink lair

Printing Notes:

• Recommended material: PLA, PCTG, PETG, or ABS
• Infill: 10–15% gyroid infill is great. My included print profile is set to 10% gyroid.
• Layer height: 0.2 mm for crisp detail
• No supports needed - modeled to not need supports

Keep your coasters stacked, your table clean, and your creativity on display. Because even coaster holders deserve a little personality.

Print out this coaster holder to start holding your coasters today. Impossible is nothing.