cable management
CR-10
CR-10 Extruder Cable Hanger
Print Profile(0)
3
1
Released 2025-07-23
Unlike many of the other cable management clips, this cable hanger was designed to hold the hot end bundle plus several more cables. It was designed to mount to the spring retaining screw of an MK8 extruder.
I added a M4 nut to the spring retaining screw, so I could tighten it down without adding too much pressure to the spring. This has only been tested on the MacEwen FlexiPLUS but may work on other MK8 extruders.
Originality of the Model
The author declares that this work is their personally shared model
Original creator:
macd2point0
Reprint source:https://www.thingiverse.com/thing:2888751
This model is licensed under the following terms:
Credit must be given to the creator
Models(1)
Cable_hanger.stl
18.83 KB
2025-07-17
No more
