A clip on camera mount for the basic Raspberry Pi camera. Clips to the mounting plate on the Ender 5 at the front to give a good angle of the lower layers, and sits inside the frame so the view isn't obscured when the plate moves up and down. Sits far enough back that the stock fan enclosure won't hit it.

I had to do a little bit of sanding of the arm where it snaps into the body so it fit snugly since although the measurements are the same, my print wasn't perfectly to size. If it's too large, forcing it in will snap the fairly thin front wall of the body.

The face should pressure fit into the body, but it's quite hard to remove afterwards.