Please Read

6/20/19 Update
Tutorial video coming soon!

*6/18/19 Update**
Updated crystal with slot for use with small flat head screwdriver for removal
Updated base for easier fit

Giant glowing crystal!! Thanks to Tothe for the original file. Rock on!... get it?

PRINT AT 75% SCALE!!!

LEDs link below.

It was a lot of trial, error and tweaking the print settings to print a hollow model out of clear PLA. Waaaaay to many to list here so please message me for the Cura Profile if interested.

Here’s the gist though:
Normal PLA print speeds\temp
No Supports
0% infill, BUT 2-3 walls
Bed adhesion (biggest headache, be prepared)
Slow down initial layer print speed by half
Increase initial layer temp by 5°
Increase initial layer extrusion factor by 50%
Bed temp 50° - 60°

https://www.amazon.com/gp/product/B00N0YC0YC/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1