A replacement cover for the lap screw. Mine became gummy so I made a replacement cover for it.
Printed in TPU. Cut the old one off and push this one on. If needed it can be warmed a bit with a hair dryer but should go on with a little persuasion.

Made 2 versions one flat topped and one with rounded edges . It was 46 degrees in the shop so the print is not perfect. But will do so I'm keeping it.

Note, I have been told if you print this with 95A filament you need to put a little glue inside otherwise it slips a little. They said if you squeezed down it still worked but adding a small amount of glue to the inside of the cover fixes it. I used 75A filament and did not notice that.