Introduction:

No prototype, no inspiration—just the result of freestyle. Hilarious!

This is the 14th piece in my mini retractable sword series, modeled in PL (Plasticitys Plastic City). It’s printed as a single piece, requiring no assembly, and takes about 2 hours to print. The dimensions are just right—perfect for both adults and kids. I plan to keep expanding this series.

It’s been ages since I last used PL—I’ve completely forgotten all the keyboard shortcuts. Hilarious!

Parameter Details: 8% spiral infill, seam alignment, no brim, standard supports (hand-drawn), and other typical settings.

Notes:

1. We recommend printing only one sword at a time to minimize the risk of failure.

2. The base of the retractable sword model is quite small. To prevent warping or layer misalignment caused by uneven adhesion, please clean the build plate, apply adhesive spray or coating, and raise the bed temperature by 5°C.

3. If the first few layers stick together tightly and you can’t finish printing, gently pry them apart with a utility knife.

4. If a particular section doesn’t extend smoothly, it may be due to slight material extrusion issues or layer misalignment. Try extending it several times—it should work out fine.

5. This test was conducted using PLA only. If you use PETG, there’s a chance of sticking or overly tight gaps that could affect retraction. We suggest drying your filament and adjusting the hole compensation settings according to your specific conditions.