CENTAURI CARBON ½ TOP COVER REPLACEMENT

UPDATE: 06/18/2026 - I tweaked the model just a little bit. Same model, I just cleaned up some the junction points between the pieces. I changed the angled side joints to straight joints like the front and rear. They line up better and the pins fit a little better. Its labeled as V2

This is a simple frame designed to house a 12x12 inch (305x305mm) sheet of plexiglass, up to 1/8 inch (3mm) thick. It is designed to the same dimensions as the stock glass cover, and can be used as a replacement for a broken top cover, or it can be used with the incredible CC1/CC2 mod by Printed Raw Designs! https://www.nexprint.com/en/PrintedRawDesigns/home?component=UserHome

https://www.nexprint.com/en/models/G8307848?printConfigId=G6884665

or

https://www.nexprint.com/en/models/G9973812?printConfigId=G1814204

It prints in four parts, all on the same plate, with no supports required. the four pieces are held together by puzzle piece-like pins and should be glued together (I used Super Glue). I've included the 3mf and STL files, as well as the STEP file for you remixers out there. 

The 3mf is for the Centauri Carbon 0.6mm nozzle, utilizing OrcaSlicer 2.4.0 Beta

Printed in Tecbears (Sunlu) high speed matte PETG black

0.24 layer height

3 walls, 10% infill

Mouse ear brims are preset, but can be changed to full brim or turned off. 

Fuzzy skin is painted as well, and it's set to painted only in the slicer. You can obviously turn this off completely or change the fuzzy skin pattern. I would recommend leaving the other parameters  and orientation as is. 

233 g filament

9h12m print time