When I was done installing my Govee RGBIC LED Strip Lights with Covers, there was a good bit of visible cord between the strip and the wall-mounted controller. And I used the entire strip, so I imagine this isn't an uncommon occurrence. With these CORD COVERS, you can quickly and neatly hide any exposed cord!

Works with the following Govee light strip models: H61B3 (9.84ft), H61B5 (16.4ft), H61B6 (32.8ft)

FEATURES:

• 2 styles to choose from: chose between FLAT and WIDE covers. I prefer the flat ones as they look more sleek from a distance, but the wide ones match the width of the Govee diffuser pieces
• 3 length options: each cover is available in 25mm, 50mm and 100mm size, allowing you to mix and match in order to cover as much or as little cable as you need
• The covers pop/slide into place, exactly like the Govee diffuser pieces!

PRINTING TIPS:

• Make sure to print on a CLEAN BED - this is especially important for the wide covers, which are oriented vertically
• If you need to print longer/shorter pieces, you CAN adjust the relevant axis (Y-axis for the flat covers, Z-axis for the wide ones). Make sure not to scale any of the other axes! (NOTE: I only tested both styles up to 100mm and cannot guarantee successful prints beyond that size, especially for the vertically-oriented wide covers)
• Adjusting any other settings (print speed, supports, orientation etc) is NOT RECOMMENDED - I did my best to adjust both profiles to minimize any risk of print failures