switch
ninendo
pro controller
controller
holder
mount
pegboard
pinboard
stand
ProControllerHolder
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
6
0
Released 2025-12-01
A simple stand for the Nintendo Switch pro controller. Probably would work for other controllers but I haven't tested. Easy print in Creality hyper PLA. Designed to go into a peg board for easy storage of controllers. Pegs are 1.24 in apart. May need adjustment to fit your peg holes. (pegs will bend slightly to fit close sizes)
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- ProControllerHolder.3mfDesigner
346.97 KB
2025-11-29
No comments yet
