Tired of floppy articulated snakes that just collapse the moment you lift them?
Meet Sssstrike! — a fully articulated 3D-printed snake with friction joints built right in. Unlike standard ball-linked snakes, this one stays in the pose you set: coil it, strike with it, or stand it tall like a cobra.

🛠️ Print Settings

• Material: PLA (any works — Matte PLA looks great)
• Layer Height: 0.20 mm
• Infill: 15–20%
• Supports: None required
• Brim: Optional for extra adhesion
• Printer: Works on most FDM printers

⚡ Features

• Friction-Based Joints → Holds its pose, no more floppy snake
• Poseable Anywhere → Coil, strike, wrap, or stand upright
• Two Build Plates Included →
  • 🐍 Large plate for maximum size
  • 🐍 Small plate for the smallest printable size
• Two Colorways Shown → Black/Red (stealth) & Gray/Yellow (battle-worn)
• Great for Display or Fidgeting

🎨 Remix & Customize

Paint or dual-color print to create your own venomous variants:

• 🖤 Red & black for a deadly look
• ⚡ Yellow & gray for a cyber-serpent vibe
• 🌈 Or go wild with rainbow filament for a fantasy snake

🔧 Recommended Tools & Materials

The following are affiliate links. If you make a purchase through them, I may earn a small commission at no extra cost to you.

• Polymaker PLA PRO
• Elegoo PLA
• ANYCUBIC PLA Plus

🐍 Get ready to Sssstrike!

Print one, pose it, and show off your best snake stance!