This is a completely print in place model, no supports needed. The print instructions are below.

Print Instructions:

1. Print the HueForge print (0mm - 2.08mm) at 100% infill.

2. The Millennium Falcon portion of the print (2.08mm - 109mm) should be printed at 10% infill, with 3 wall loops, 3 top and bottom surfaces. I used a layer height of 0.16mm.

3. You can achieve this by using a layer height modifier in your slicer to modify layers 2.08mm-109m.

4. You do not need any supports for this print.

5. I used Burnt Titanium as the background for the print, but you can use any variation of a dark or black colour.

6. I used Polymaker's Starlight Mercury for the Millennium Falcon, but you can use any gray or silver variant, or whatever you like!

Filament Swaps: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:

• PLA Flashforge Burnt Titanium Transmission Distance: 2.5 - (You can use black!)

• PLA META Sunlu Teal Transmission Distance: 5.4

• PLA Kingroon White Transmission Distance: 8

• PLA Polymaker Starlight Mercury (This is for the Millennium Falcon!)

Swap Instructions:

• Start with Burnt Titanium

• At layer #7 (0.68mm) swap to Teal

• At layer #11 (1mm) swap to White

• At layer #23 (1.96) swap to Starlight Mercury (this is the Falcon!)

The wonderful Millennium Falcon model was sourced from here by Gareth42. If you haven't yet, you should definitely print the standalone model, because it it marvellous!

Have fun, and let me know how you go with the print!