Description:

A small and cute spider twisting around your hair comb.

I would like to point out that, while the combs can be used independently to hold the hair in place with certain hairstyles and hair types, they are mainly designed for decorative use and therefore it may be necessary to use a hair tie to secure the desired hairstyle.

Printing instructions:

The support is already set up to meet the needs of the model. I used an angle that concentrates the support marks on the back of the model, towards the head, so as to leave the front part exposed to the outside perfectly smooth.

Assembly instructions:

No assembly to do as the model is made in one piece.

Post-processing:

Removing the support is quite simple and does not take much time. You can use a bit of sandpaper on the back of the model, in case the surface is too rough against the scalp due to the marks left by the support.