I came across Henryb2015 Funko Comic Covers display shelf while looking for a wall mount for my new Funko Boba Fett Comic Covers Pop. while the shelf was perfect, it was a little too small for Boba so I remixed to suit my needs. I stretched out the base while following the hex pattern rather than just scaling it. I also changed the back panel as I use command strips and wanted more surface area since its rather large. But I added back the screw holes for people who want to screw it too the wall.

I couldn't keep well enough alone so I came up with a little nameplate, their is a nameplate for Boba Fett, a blank nameplate so you can just add you're own text for any different characters. There's also just a plain Funko Comic Covers plate. I just attach these with some CA glue to the knob on the front of the stands, there is also stands without the nameplate mount if you aren't going to use them.

Too get a similar font to the Funko Pop text I used Helvetica Neue LT Pro 87 Heavy Condensed and a website called text2stl. You can then generate the stl and import it into the workplate and scale it to fit, I used the dimensions of about 70mm x 10mm x 4mm.

There is a negative object underneath the nameplate to make gluing to the stand mount a little easier so you'll need to use supports.

The name plate uses 5 different colours, so i added a pause at 3.40mm layer height and swap out the blue filament for yellow. When sending the job to the printer, I just select the filament colours like this