This is the most satisfying accessory I’ve designed specifically for the CC2—both aesthetically pleasing and highly practical. It requires only one spool of filament, and with PETG costing just over ten yuan, you can easily create a very useful upgrade component for your CC2. The print time is about 13 hours and 40 minutes, so it can be completed in a single day.

The entire part uses approximately 912 grams of filament. It features two drawers; the longer version includes handles that require two small screws (M2–M3 × 8 mm), while the shorter version is only 5 mm shorter. The handles are integrally printed, but if preferred, you can opt for a single‑spool configuration to produce two pieces, or choose the version without handles altogether. Additionally, the two small handles on the four‑spool version can also be omitted, allowing you to assemble and install the piece directly after printing—no screws needed.

This accessory raises the CC2 by roughly 4 cm and incorporates two front-facing drawers, each approximately 245 mm long, 125 mm wide, and 38 mm deep. It provides perfect storage for commonly used tools such as hex keys, screwdrivers, putty knives, craft knives, cleaning brushes, adhesive tape, spare nozzles, build‑plate adhesives, and other accessories—keeping everything neat and organized. If you own a CC2, this is an essential model you simply must have.