Button-cell battery cover, toy car battery cover
Print Profile(1)
- 0.2 mm layer height, 2‑wall walls, 15% infill density
2-disc
PETG
Designer
1
0
Released 2026-07-22
The battery cover for the toy car at home was missing, so I 3D-printed a replacement; it can accommodate two or three cells in series, with two different configurations.
Also, just a heads-up: the screws used on toy car covers are typically M2.5.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- 纽扣电池电池盖.3mfDesigner
177.88 KB
2026-07-18
No comments yet
