Color layering was created using ChromaPrint3D, with Topray RBWYW 4-color filament, a layer height of 0.08 mm, and 5 layers of color‑layer stacking.

The image was generated using the anima model.

A template for fabrication is provided; note that due to variations in filament shrinkage, it’s advisable to print the template first as a test, then fine-tune it (make sure the three sub‑components remain consistent—do not modify only one).

Pay attention to the stacking order of the template and the color‑layered assembly: the base plate should be placed on top. Refer to my setup for specifics.

The thickness of the flat color‑layered plate should not exceed 2 mm.

I printed with a 0.4 mm nozzle; the resulting image isn’t very sharp—using a 0.2 mm nozzle would likely yield better results.

Once your custom color‑layered model is properly positioned, combine it with the template, remembering to move the base‑plate component from the template to the top layer.