This version is specially designed for female 3D printing enthusiasts. Whether or not you have an AMS multi-color system, you can easily print this beautifully color-separated Sailor Moon–style JK bag!

Thanks to its clever modular design, you can use a single-color printer to print each part in its respective color, then assemble it with snap-fit joints and just a bit of glue. This approach not only minimizes waste from frequent color changes but also allows for highly customized results by simply swapping filament colors.

🛠️ Print Instructions / Print Settings (Optimized for Single Extruder)

• Color‑separation printing recommendations:

  • White parts: Bag body (Body)

  • Blue parts: Bag flap (Flap)

  • Red parts: 3D bow (Bow)

  • Gold parts: Central decorative button

• Filament selection: PLA is recommended—either the full set of TopSeed official colors or Colorful House’s “99 Gold.”For the connection at the back of the bag, prepare a piece of filament to thread through and enable the bag to open and close.

• Support recommendations: All parts have been optimized so that they are essentially support-free or require only minimal supports, greatly reducing printing complexity.

🔧 Assembly Guide / Assembly Instructions

To ensure structural stability, please follow these steps:

1. Clean the snap-fit areas: After printing, inspect and remove any fine filaments around the snap-fit joints to ensure precise alignment.

2. Assemble using snap-fit connections: Attach the blue flap to the white bag body via the pre‑designed snap-fit, threading filament through the joint during assembly.

3. Reinforce with glue: Apply a small amount of 401 glue or B7000 adhesive to the back of the bow and the central button, press firmly for 30 seconds to secure them in place.

4. Install accessories: Standard 4mm holes on the sides allow you to attach Luna cat charms or commercially available metal shoulder straps.

✨ Why choose this version? / Why download this?

• Zero waste: Compared to the frequent material changes required by AMS systems, this modular approach produces virtually no filament waste (Poop).

• Smoother surface finish: Since each part can be oriented optimally during printing, the surface texture turns out exceptionally smooth.

• Beginner-friendly: Significantly reduces common issues like color blending or nozzle clogging often encountered in multi‑color printing.