096 Intercontinental Ballistic Missile Nuclear Submarine

This is a highly detailed model that has been optimized for easy printing. The model has been specifically tailored for 3D printing.

More imaginative details have been added; it does not replicate the original exactly.

The hatch and missile silo covers are openable, allowing space to accommodate 20 missiles.

Printing Tips:
Print Bed: Use a textured PEI bed.
Material: PLA
Layer Height: 0.12 mm
Number of Outer Wall Layers: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be necessary. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and make sure your filament is dry.
Special thanks to all friends who have followed, liked, downloaded, and supported this project!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12 mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and make sure your filament is dry.

Special thanks to all friends for your attention, likes, downloads, and support!