A simple yet practical holder for toothbrushes, razors, toothpaste, and facial cleanser.

The base has a maximum height of 120 mm at its curved apex and a width of 50 mm.

The circular toothpaste holder on the base measures 38 mm in diameter.

The overall height is 80 mm.

The circular opening (large enough to accommodate a toothbrush handle) has a diameter of 19 mm.

Printed in one piece using PETG, with a layer height of 25 µm and a print time of approximately 55 minutes. PLA can also be used; the silk‑colored two‑tone version shown in the image is made from PLA, though prolonged exposure to moisture may cause mild mold growth on the base.

Design Rationale:

1. Printing Orientation: Lying flat during printing

      a. When the column‑shaped bracket is oriented vertically downward, water drains more effectively and dirt accumulation is minimized.

      b. This orientation also enhances structural strength between the column and the base.

2. Overall design incorporates smooth, curved lines.

3. The base features a drainage channel.

      By hollowing out the bottom of the toothbrush, toothpaste dispenser, and other items, water does not pool or cause discoloration, making daily cleaning much easier.

4. Supports are optional—both versions shown in the image were printed with supports. The white version uses supports only at the two circular rings at the top of the bracket, while the blue version was printed without them. Print quality is comparable, with minor imperfections visible only around the overhanging curved sections.